Modeling of the Concentrations of Ultrafine Particles in the Plumes of Ships in the Vicinity of Major Harbors

Show full item record



Permalink

http://hdl.handle.net/10138/313838

Citation

Karl , M , Pirjola , L , Karppinen , A , Jalkanen , J-P , Ramacher , M O P & Kukkonen , J 2020 , ' Modeling of the Concentrations of Ultrafine Particles in the Plumes of Ships in the Vicinity of Major Harbors ' , International Journal of Environmental Research and Public Health , vol. 17 , no. 3 , 777 . https://doi.org/10.3390/ijerph17030777

Title: Modeling of the Concentrations of Ultrafine Particles in the Plumes of Ships in the Vicinity of Major Harbors
Author: Karl, Matthias; Pirjola, Liisa; Karppinen, Ari; Jalkanen, Jukka-Pekka; Ramacher, Martin Otto Paul; Kukkonen, Jaakko
Contributor organization: Department of Physics
Date: 2020-02-01
Language: eng
Number of pages: 24
Belongs to series: International Journal of Environmental Research and Public Health
ISSN: 1661-7827
DOI: https://doi.org/10.3390/ijerph17030777
URI: http://hdl.handle.net/10138/313838
Abstract: Marine traffic in harbors can be responsible for significant atmospheric concentrations of ultrafine particles (UFPs), which have widely recognized negative effects on human health. It is therefore essential to model and measure the time evolution of the number size distributions and chemical composition of UFPs in ship exhaust to assess the resulting exposure in the vicinity of shipping routes. In this study, a sequential modelling chain was developed and applied, in combination with the data measured and collected in major harbor areas in the cities of Helsinki and Turku in Finland, during winter and summer in 2010-2011. The models described ship emissions, atmospheric dispersion, and aerosol dynamics, complemented with a time-microenvironment-activity model to estimate the short-term UFP exposure. We estimated the dilution ratio during the initial fast expansion of the exhaust plume to be approximately equal to eight. This dispersion regime resulted in a fully formed nucleation mode (denoted as Nuc(2)). Different selected modelling assumptions about the chemical composition of Nuc(2) did not have an effect on the formation of nucleation mode particles. Aerosol model simulations of the dispersing ship plume also revealed a partially formed nucleation mode (Nuc(1); peaking at 1.5 nm), consisting of freshly nucleated sulfate particles and condensed organics that were produced within the first few seconds. However, subsequent growth of the new particles was limited, due to efficient scavenging by the larger particles originating from the ship exhaust. The transport of UFPs downwind of the ship track increased the hourly mean UFP concentrations in the neighboring residential areas by a factor of two or more up to a distance of 3600 m, compared with the corresponding UFP concentrations in the urban background. The substantially increased UFP concentrations due to ship traffic significantly affected the daily mean exposures in residential areas located in the vicinity of the harbors.
Subject: shipping emissions
ultrafine particles
fuel sulfur content
aerosol dynamics modeling
atmospheric nucleation
particle number concentration
air quality
population exposure
PARTICULATE AIR-POLLUTION
ACID-WATER NUCLEATION
SULFURIC-ACID
SIZE DISTRIBUTIONS
HEAVY-DUTY
NUMBER CONCENTRATIONS
POPULATION EXPOSURE
EXHAUST EMISSIONS
OXIDATIVE STRESS
ORGANIC VAPORS
114 Physical sciences
3142 Public health care science, environmental and occupational health
Peer reviewed: Yes
Rights: cc_by
Usage restriction: openAccess
Self-archived version: publishedVersion


Files in this item

Total number of downloads: Loading...

Files Size Format View
ijerph_17_00777_v2.pdf 3.888Mb PDF View/Open

This item appears in the following Collection(s)

Show full item record