Orientation of faults and their potential for reactivation in the present stress field in Finland

Show full item record



Permalink

http://urn.fi/URN:NBN:fi-fe2017112251755
Title: Orientation of faults and their potential for reactivation in the present stress field in Finland
Author: Koskinen, Paula
Contributor: University of Helsinki, Faculty of Science, Department of Physics
Publisher: Helsingfors universitet
Date: 2013
Language: eng
URI: http://urn.fi/URN:NBN:fi-fe2017112251755
http://hdl.handle.net/10138/41969
Thesis level: master's thesis
Discipline: Geophysics
Geofysiikka
Geofysik
Abstract: Finland is situated in an intraplate area of low seismicity. Seismic hazard analyses require an assessment of regional maximum earthquake magnitude. One of the methods for estimating maximum magnitude is relating it to the dimensions of active faults. Intraplate earthquakes usually occur when pre-existing zones of weakness are reactivated in response to the ambient stress field. Because minor earthquakes rarely cause surface ruptures, the reactivated faults have to be studied by indirect means. In this study structural lineaments are used as proxies for old shear zones, faults and fractures. Their orientation with respect to the crustal stress field is determined in order to find potentially unstable faults. Firstly the orientation of the stress field is determined by reviewing literature and available data on crustal stress in Finland. The main force causing the compressive stress field in Fennoscandia is the spreading of the mid-Atlantic ridge, which is why the plate motion of Finland relative to North America is also taken into account. An estimate of 115° to 135° is reached for the azimuth of the maximum horizontal stress in Finland. The stress regime is mostly reverse (minimum principal stress is vertical) according to stress indicators and focal mechanisms. The lineaments are split into straight segments for azimuth calculation. The segments are then divided into optimal orientation categories based on the horizontal angle between the segment and the maximum horizontal stress. Reverse faulting takes place perpendicular to and normal as well as transfer faulting takes place parallel to the maximum horizontal stress. The direction of strike-slip faulting depends on the coefficient of internal friction, which is around 0.6 for solid rock and as low as 0.2-0.4 for pre-existing fractures. With these values the Coulomb failure criterion gives an optimal angle of 30° to 40° to the maximum horizontal stress for strike-slip faulting. The lineament segments with the different faulting categories are shown with different colours in order to better visualise the regions hosting similar faulting directions. Some coefficients of internal friction were also calculated based on available stress magnitudes by assuming frictional equilibrium of pre-existing, optimally oriented zones of weakness. The data were scarce and only available for shallow depths. The calculated coefficients are quite high (0.7-0.8) near the surface and decrease with depth down to 0.4. A maximum earthquake magnitude of approximately 7 is suggested based on lengths of the lineament segments. An earthquake of such magnitude has a very low probability of occurring in Finland. This leads to the conclusion that the datasets used are too coarse for reliable estimates of fault length. Finally, the lineament orientations are compared with seismicity data. In western Lapland earthquakes are clearly linked to a reverse and transfer faulting system. In order to find differences in earthquake source mechanisms the earthquakes are divided into three depth categories. It seems that shallow earthquakes of depths less than 5 km most often occur near lineaments likely to reactivate as reverse and transfer faults, whereas earthquakes deeper than 15 km occur closer to lineaments optimal for strike-slip faulting. Earthquakes between the depths of 5 km and 15 km occur near lineaments of all orientations. The lineament orientation and seismicity maps will hopefully prove useful in further studies concerning the present structural framework of the Finnish crust. For reliable estimates of maximum earthquake magnitude based on fault length in Finland, faults should be studied in greater detail.


Files in this item

Total number of downloads: Loading...

Files Size Format View
Progradu_PK.pdf 15.00Mb PDF View/Open

This item appears in the following Collection(s)

Show full item record